Installation method: Paste (3M glue on the back. The temperature should be below 15 degrees and must be heated and pasted!)
1. Surface cleaning. (The surface to be adhered must be absolutely clean and dry. Generally, the cloth can be cleaned with 50% alcohol, isopropyl alcohol, acetone or toluene. The solvent-cleaned surface must be thoroughly used. Can be pasted.)
2. The product is pasted. (Before the product is pasted, the product should be placed in the required installation. After confirming the position of the product, remove the red film and paste it. Avoid contact between the finger and the rubber surface during operation. After the pressure must be pressed to ensure sufficient contact and wetting of the rubber surface.)
3. The product and parts need to be contacted with water and large dust within 24 hours to achieve the best adhesion.
Note: Please choose to install on a sunny day. Always clean the paste position with a cleaning agent before installation and press it for a while. Do not wash your car within 2 days. If it is colder weather, please use a hair dryer to bake slightly to maintain the softness and viscosity of the gel.